Introduction of emergency methods for automobile chassis system damage

When it comes to car maintenance, chassis care is easy to be ignored by the driver friends, but in winter or wet weather the importance of chassis maintenance is very obvious. In winter to the chassis maintenance to do chassis cleaning and rust treatment. First of all, we should clean the chassis. If there is too much dirt on the chassis, we should also use the cleaning agent to wash it again, so that the chassis reveals the original "true color", so that the antirust care can start. In a professional beauty shop, the car can be lifted to the lifting frame for chassis cleaning, wiping, and then anti-rust care. In this middle, we should note that after cleaning, we must wait until the moisture on the chassis is dry, in order to carry out anti-rust care. In the care, be sure to maintain a uniform spray coating, forming a layer of durable uniform antirust coating. After the completion of all the natural air drying 5-10 minutes, chassis rust treatment is completed.

After the professional chassis care, also does not mean that foolproof, there is a mistake, that is often people in order to love the car will wash the car itself, which will often add some cleaning agent, then please pay attention not to use alkaline cleaning agent washing powder wash body and chassis, otherwise it will affect the anti-rust effect and shorten the anti-rust time.

It is recommended that you go to a professional beauty shop to do brand care. There is a simple way to try out the quality of the chassis after finishing the antirust care, almost no water drops are hung after the high-pressure water spraying. This effect represents the genuine care and can play a very good antirust protection effect.

When the car is in the field or far away from the repair site and the chassis parts are damaged, the following first aid methods can be used to drive the car to the place with repair conditions according to different fault situations.

Brake pump leakage brake fluid or branch pump pipe broken, can be in the branch pump pipe joint with iron sheet, copper to make a small mat, the pipeline is blocked, and then tighten the screw, or the fracture clamp flat, crimped plugging, so that the wheel can not brake.

The brake master pump is short of brake fluid, which can be replaced by alcohol or liquor, and can be replaced by clean water under special circumstances. Stop the swelling of the skin bowl. Soak the swollen skin bowl in hot water for 10-20 minutes. Remove the oily ingredients from the skin bowl, so that the skin bowl can return to its original size.

Clutch friction plate ablative slip, not too serious ablative friction plate, can be turned over to use. If the ablation is serious, several layers of cotton cloth or canvas can be used, and steel wire or iron wire can be passed through the holes on the steel sheet to make it fixed. When driving a vehicle, it should start smoothly and shift quickly.

Transverse tie rod ball joint broken, in the bumper or other places do not affect the driving, unload a screw with the total length of the ball joint similar to the broken ball joint, replace the broken ball joint, installed on the steering knuckle arm and nut, the screw exposed part with hammer riveting good. If the differential gear of a three-axle vehicle is damaged, such as the middle and rear axle differential is damaged, the drive shaft and half shaft of the axle can be removed and the vehicle can continue to drive. If the front differential is damaged, you can remove the hub joint plate and continue driving.